Accessories that fit iPhone 15 Plus

iOttie's adjustable cradle accepts phones up to 3.6 inches wide, covering every target iPhone chassis.

Safe use: Confirm that the phone and case fit within the 3.6-inch cradle width and mount only on a safe, unobstructed vehicle surface.

Spigen specifies the TS35-1 universal clamp for most smartphones and cases rather than a proprietary phone shell.

Safe use: Verify the case sits securely in the clamp and keep the mounted phone clear of the driver's view and vehicle controls.

OtterBox's first-party compatibility material identifies the Commuter Series Case as molded for iPhone 15 Plus and iPhone 14 Plus.

Before you buy: Use only with the exact iPhone model or shared-fit group named; camera, button, and port geometry differs across other iPhones.

OtterBox's first-party compatibility material identifies the Defender Series Case as molded for iPhone 15 Plus and iPhone 14 Plus.

Before you buy: Use only with the exact iPhone model or shared-fit group named; camera, button, and port geometry differs across other iPhones.

Apple specifies USB-C connectors at both ends and lists the two-meter cable for current USB-C iPhone families.

Required specification: A compatible USB-C power adapter is required; the 240W rating is the cable maximum, not the iPhone charging rate.

Apple specifies USB-C connectors at both ends and lists the cable for USB-C iPhone families.

Required specification: A compatible USB-C power adapter is required; the iPhone negotiates only the charging power it supports.

Lamicall specifies a 4-to-8-inch device range and open cradle, covering every target iPhone from iPhone 5 onward.

Fit limitation: Oversized rear wallets or unusually thick cases may exceed the 0.71-inch cradle-depth allowance.

Nulaxy's open universal smartphone cradle has no model-specific shell and supports portrait or landscape placement.

Before you buy: Center the phone on the cradle and remove oversized rear-mounted accessories if they prevent stable contact.

Ringke's two-card holder attaches to a flat phone case with replaceable 3M adhesive and does not depend on model-specific magnets.

Before you buy: Attach to a smooth compatible case or use the recommended protective film on glass; remove before wireless charging when it interferes.

Sinjimoru specifies its flexible adhesive pouch for smartphones with enough flat rear area, independent of the phone connector or magnet system.

Before you buy: Use a smooth case or supplied adhesion film on glass; verify the pouch does not cover the camera and remove it if it obstructs wireless charging.

Anker documents a regulated USB-A output; each iPhone charges through the correct USB-C, Lightning, or 30-pin cable selected on its cable page.

Required specification: Use the correct cable for the iPhone connector; this power bank does not include every legacy cable.

Anker documents both USB-C PD and USB-A outputs, allowing every target iPhone to charge through its correct cable.

Required specification: Use the correct cable for the iPhone connector; actual charging speed is negotiated by the phone.

Supershieldz lists this tempered glass protector for the exact display dimensions and cutout geometry of iPhone 16 Plus and iPhone 15 Plus.

Before you buy: Install only on the exact model or shared display-fit group named and remove any existing screen film first.

Supershieldz lists this PET protector for the exact display dimensions and cutout geometry of iPhone 16 Plus and iPhone 15 Plus.

Before you buy: Install only on the exact model or shared display-fit group named and remove any existing screen film first.

Apple identifies the charger as Qi2/Qi certified and usable with iPhone 8 or later.

Feature limitation: Magnetic alignment applies only to MagSafe-equipped iPhones; center earlier Qi iPhones manually and use a compatible USB-C adapter.

Belkin specifies F7U052 for Qi-enabled devices and iPhone 8 or later.

Before you buy: Center the phone on the stand and use a compatible power adapter; thick or metal-backed cases can interrupt charging.